... enhancement Heat recovery The coke oven gas embraces 27∼30% of heat energy supplied by the coal during its coking [ 1 ]. It is now recovered mainly using a heat exchanger in ascension pipe. Some technologies have been proposed for recovery of this enormous energy, such as the jacket technology...

.... , and Dincer , I. , 2011 , “ Heat Recovery From a Cement Plant With a Marnoch Heat Engine ,” Appl. Therm. Eng. , 31 (10) , pp. 1734 – 1743 . 10.1016/j.applthermaleng.2011.02.016 [13] Eklund , J. M. , Kwok , Y. F. , Zheng , J. , and Marnoch , I. A. , 2009 , Controller...

...Isak Kotcioglu; Ahmet Cansiz In this study, a cross-flow heat recovery-exchanger system operating with unmixed fluids was manufactured and tested. The thermodynamic analysis of the system was presented via determining the variations of exergy loss with Reynolds number. The analysis also included...

... 2003 cooling towers pipe flow thermal resistance heat transfer condensers (steam plant) Cooling Towers Fouling Heat Transfer Heat Recovery The two subject areas of fouling and enhancement have been developed mainly independently for many years. Watkinson 1 had attempted...

... reactive flow confined flow two-phase flow Engines Heat Transfer Heat Recovery Porous Media Regenerators A regenerative Diesel engine using an in-cylinder reciprocating, porous regenerator as shown in Fig. 1 has the potential to improve fuel-air mixing and combustion 1 2 3...

.../frosting for extreme operating conditions. 03 Sept 1997 30 Mar 1998 05 12 2007 Condensation Heat Transfer Heat Recovery Moisture Sorption ASHRAE, 1992, Desiccant cooling and dehumidification , L. Harriman, ed., American Society of Heating, Refrigerating and Air...

...: Heat Exchangers, Heat Pipes and Thermosyphons, Heat Recovery. Associate Technical Editor: J. H. Kim. angled form, some empirical observations have appeared (Zar- ling and Haynes, 1987; Haynes et al., 1991), but there appear to have been few, if any, fundamental investigations. The purpose of this note...

... core for equal pressure drops and effec- tiveness. 1 Introduction Air-to-air heat exchangers are becoming more popular in HVAC applications, in process heat recovery and drying ap- plications in the paper, food, steel and chemical industries, and in regenerative gas turbine systems. These exchangers...

... February 1990 23 05 2008 Conduction Heat Recovery Modeling and Scaling L. S. Fletcher Dietz Professor of Mechanical Engineering. Fellow ASME G. P. Peterson Professor of Mechanical Engineering. Mem. ASME 'Dept. of Mechanical Engineering, Texas A&M University, College Station, TX 77843 C. V...

... of the fluids proceeds through the exchanger in a single, mixed stream. The property is illustrated with several examples from the available literature. 14 September 1987 20 10 2009 Heat Exchangers Heat Recovery A. Pignotti TECHINTS.A., 1001 Buenos Aires, Argentina Relation Between...

... Transfer Division and presented at the 24th National Heat Transfer Conference, Pittsburgh, Pennsylvania, August 9-12, 1987. Man- uscript received bv the Heat Transfer Division June 26, 1987. Keywords: Heat Exchangers, Heat Recovery, Packed and Fluidized Beds. exist variations in the thermal loads...

... Transfer Division September 30, 1987. Keywords: Heat Exchangers, Heat Recovery, Thermodynamics and Second Law. A5 Vi ABh and B V2: B,, (1) (2) while Witte and Shamsundar (1983) introduced the following definition: : 1 - / (3) where Q is the required heat rate for the exchanger, called the "heat duty...

.... Contributed by the Heat Transfer Division for publication in the JOURNAL OF HEAT TRANSFER. Manuscript received by the Heat Transfer Division October 15, 1986. Keywords: Heat Exchangers, Heat Recovery, Radiation. tact radiation effect (Olalde et al., 1980). With a high fluid temperature, it would seem...