The closed-loop Brayton cycle with supercritical CO2 (S-CO2) as an operating fluid is an attractive alternative to conventional power cycles due to very high power density. Foil gas bearings using CO2 are the most promising for small S-CO2 turbomachinery but there are many problems to address: large power loss due to high flow turbulence, lack of design/analysis tool due to nonideal gas behavior, and lack of load capacity when they are used for large systems. This paper presents high-level design/analysis tool involving three-dimensional (3D) thermohydrodynamic (THD) analyses of radial foil bearings considering real gas effect and flow turbulence inside the film. Simulations are performed for radial foil bearing with 34.9 mm in diameter and lubricated with CO2 and N2 under various ambient conditions up to above 40 bar gauge pressure. The simulation results using the turbulence model still underpredict the measured data in open literature. However, the error between the prediction and measurements decreases as either speed or ambient pressure increases. In addition, general behavior of substantial increase in power loss with ambient pressure agrees with the measured data. The simulation results indicate the importance of detailed THD analysis of the foil bearings for prediction of power loss under severe turbulent condition. A conceptual layout of rotor system for 10 MWe S-CO2 loop is also presented along with realistic rotor weight and bearing load. A hybrid foil bearing with diameter of 102 mm is suggested for gas generator rotor, and its power losses and minimum film thicknesses at various operating conditions are presented.
Skip Nav Destination
Article navigation
March 2016
Research-Article
Design Space of Foil Bearings for Closed-Loop Supercritical CO2 Power Cycles Based on Three-Dimensional Thermohydrodynamic Analyses
Daejong Kim
Daejong Kim
Mechanical and Aerospace Engineering,
The University of Texas at Arlington,
500 West 1st Street,
Arlington, TX 76019
e-mail: daejongkim@uta.edu
The University of Texas at Arlington,
500 West 1st Street,
Arlington, TX 76019
e-mail: daejongkim@uta.edu
Search for other works by this author on:
Daejong Kim
Mechanical and Aerospace Engineering,
The University of Texas at Arlington,
500 West 1st Street,
Arlington, TX 76019
e-mail: daejongkim@uta.edu
The University of Texas at Arlington,
500 West 1st Street,
Arlington, TX 76019
e-mail: daejongkim@uta.edu
Contributed by the Structures and Dynamics Committee of ASME for publication in the JOURNAL OF ENGINEERING FOR GAS TURBINES AND POWER. Manuscript received July 13, 2015; final manuscript received August 12, 2015; published online October 6, 2015. Editor: David Wisler.
J. Eng. Gas Turbines Power. Mar 2016, 138(3): 032504 (9 pages)
Published Online: October 6, 2015
Article history
Received:
July 13, 2015
Revised:
August 12, 2015
Citation
Kim, D. (October 6, 2015). "Design Space of Foil Bearings for Closed-Loop Supercritical CO2 Power Cycles Based on Three-Dimensional Thermohydrodynamic Analyses." ASME. J. Eng. Gas Turbines Power. March 2016; 138(3): 032504. https://doi.org/10.1115/1.4031433
Download citation file:
Get Email Alerts
Image-based flashback detection in a hydrogen-fired gas turbine using a convolutional autoencoder
J. Eng. Gas Turbines Power
Fuel Thermal Management and Injector Part Design for LPBF Manufacturing
J. Eng. Gas Turbines Power
An investigation of a multi-injector, premix/micromix burner burning pure methane to pure hydrogen
J. Eng. Gas Turbines Power
Related Articles
Effect of Operating Conditions on the Elastohydrodynamic Performance of Foil Thrust Bearings for Supercritical CO 2 Cycles
J. Eng. Gas Turbines Power (April,2017)
Development of a Computational Tool to Simulate Foil Bearings for Supercritical CO 2 Cycles
J. Eng. Gas Turbines Power (September,2016)
Development of Large-Diameter Hybrid Film-Riding Seals for Supercritical Carbon Dioxide Turbines
J. Eng. Gas Turbines Power (February,2025)
Low-Leakage Shaft-End Seals for Utility-Scale Supercritical CO 2 Turboexpanders
J. Eng. Gas Turbines Power (February,2017)
Related Proceedings Papers
Related Chapters
Compressive Deformation of Hot-Applied Rubberized Asphalt Waterproofing
Roofing Research and Standards Development: 10th Volume
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Natural Gas Transmission
Pipeline Design & Construction: A Practical Approach, Third Edition