Experimental data for the void fraction and two-phase frictional pressure drop from various sources has been compiled and analyzed. The experimental data revealed that at the lower range of superficial gas velocity and void fraction, the variations of the two-phase frictional pressure drop with superficial gas velocity and void fraction are relatively flat. However, as the superficial gas velocity and void fraction increase to higher values, the frictional pressure drop became significantly sensitive to the two parameters. In a situation when the two-phase pressure drop is sensitive to the variation of the void fraction, it is then that the proper and accurate characterization of the void fraction becomes significant. From the experimental data, regions where the pressure drop is sensitive to the variation of the void fraction are identified and evaluated.
Skip Nav Destination
Article navigation
February 2013
Research-Article
Effect of Void Fraction on Pressure Drop in Upward Vertical Two-Phase Gas-Liquid Pipe Flow
Clement C. Tang,
Sanjib Tiwari,
Sanjib Tiwari
e-mail: sanjib.tiwari@my.und.edu
University of North Dakota,
Mechanical Engineering Department
,University of North Dakota,
Grand Forks, ND 58202
Search for other works by this author on:
Afshin J. Ghajar
Afshin J. Ghajar
School of Mechanical and Aerospace Engineering,
e-mail: afshin.ghajar@okstate.edu
Oklahoma State University
,Stillwater, OK 74078
e-mail: afshin.ghajar@okstate.edu
Search for other works by this author on:
Clement C. Tang
e-mail: clement.tang@engr.und.edu
Sanjib Tiwari
e-mail: sanjib.tiwari@my.und.edu
University of North Dakota,
Mechanical Engineering Department
,University of North Dakota,
Grand Forks, ND 58202
Afshin J. Ghajar
School of Mechanical and Aerospace Engineering,
e-mail: afshin.ghajar@okstate.edu
Oklahoma State University
,Stillwater, OK 74078
e-mail: afshin.ghajar@okstate.edu
Contributed by the Nuclear Division of ASME for publication in the Journal of Engineering for Gas Turbines and Power. Manuscript received September 13, 2012; final manuscript received September 19, 2012; published online January 8, 2013. Editor: Dilip R. Ballal.
J. Eng. Gas Turbines Power. Feb 2013, 135(2): 022901 (7 pages)
Published Online: January 8, 2013
Article history
Received:
September 13, 2012
Revision Received:
September 19, 2012
Citation
Tang, C. C., Tiwari, S., and Ghajar, A. J. (January 8, 2013). "Effect of Void Fraction on Pressure Drop in Upward Vertical Two-Phase Gas-Liquid Pipe Flow." ASME. J. Eng. Gas Turbines Power. February 2013; 135(2): 022901. https://doi.org/10.1115/1.4007762
Download citation file:
Get Email Alerts
Study of Injector Geometry and Parcel Injection Location on Spray Simulation of the Engine Combustion Network Spray G Injector
J. Eng. Gas Turbines Power (July 2023)
Fully Coupled Analysis of Flutter Induced Limit Cycles: Frequency Versus Time Domain Methods
J. Eng. Gas Turbines Power (July 2023)
Impact of Ignition Assistant on Combustion of Cetane 30 and 35 Jet-Fuel Blends in a Compression-Ignition Engine at Moderate Load and Speed
J. Eng. Gas Turbines Power (July 2023)
Related Articles
Two-Phase Flow Through Square and Circular Microchannels—Effects of Channel Geometry
J. Fluids Eng (July,2004)
Effect of Capsule Density and Concentration on Pressure Drops of Spherical Capsule Train Conveyed by Water
J. Fluids Eng (January,2010)
Pressure Drop and Void Fraction in Steam-Water Two-Phase Flow at High Pressure
J. Heat Transfer (August,2013)
A Robust Asymptotically Based Modeling Approach for Two-Phase Flow in Porous Media
J. Heat Transfer (October,2009)
Related Chapters
Completing the Picture
Air Engines: The History, Science, and Reality of the Perfect Engine
Experimental Characterization of a Cavitating Orifice
Proceedings of the 10th International Symposium on Cavitation (CAV2018)
Basics of Hydraulic Loops
Hydraulics, Pipe Flow, Industrial HVAC & Utility Systems: Mister Mech Mentor, Vol. 1