A novel combustor design, referred to as a stagnation-point reverse-flow (SPRF) combustor, was recently developed to overcome the stability issues encountered with most lean premixed combustion systems. The SPRF combustor is able to operate stably at very lean fuel-air mixtures with low emissions. The reverse flow configuration causes the flow to stagnate and hot products to reverse and leave the combustor. The highly turbulent stagnation zone and internal recirculation of hot product gases facilitates robust flame stabilization in the SPRF combustor at very lean conditions over a range of loadings. Various optical diagnostic techniques are employed to investigate the flame characteristics of a SPRF combustor operating with premixed natural gas and air at atmospheric pressure. These include simultaneous planar laser-induced fluorescence imaging of OH radicals and chemiluminescence imaging, and spontaneous Raman scattering. The results indicate that the combustor has two stabilization regions, with the primary region downstream of the injector where there are low average velocities and high turbulence levels where most of the heat release occurs. High turbulence levels in the shear layer lead to increased product recirculation levels, elevating the reaction rates and thereby enhancing the combustor stability. The effect of product entrainment on the chemical time scales and the flame structure is quantified using simple reactor models. Turbulent flame structure analysis indicates that the flame is primarily in the thin reaction zone regime throughout the combustor. The flame tends to become more flameletlike, however, for increasing distance from the injector.
Skip Nav Destination
Article navigation
Research Papers
Flame Structure and Stabilization Mechanisms in a Stagnation-Point Reverse-Flow Combustor
Mohan K. Bobba,
Mohan K. Bobba
School of Aerospace Engineering,
Georgia Institute of Technology
, Atlanta, GA 30332-0150
Search for other works by this author on:
Priya Gopalakrishnan,
Priya Gopalakrishnan
School of Aerospace Engineering,
Georgia Institute of Technology
, Atlanta, GA 30332-0150
Search for other works by this author on:
Karthik Periagaram,
Karthik Periagaram
School of Aerospace Engineering,
Georgia Institute of Technology
, Atlanta, GA 30332-0150
Search for other works by this author on:
Jerry M. Seitzman
Jerry M. Seitzman
School of Aerospace Engineering,
Georgia Institute of Technology
, Atlanta, GA 30332-0150
Search for other works by this author on:
Mohan K. Bobba
School of Aerospace Engineering,
Georgia Institute of Technology
, Atlanta, GA 30332-0150
Priya Gopalakrishnan
School of Aerospace Engineering,
Georgia Institute of Technology
, Atlanta, GA 30332-0150
Karthik Periagaram
School of Aerospace Engineering,
Georgia Institute of Technology
, Atlanta, GA 30332-0150
Jerry M. Seitzman
School of Aerospace Engineering,
Georgia Institute of Technology
, Atlanta, GA 30332-0150J. Eng. Gas Turbines Power. May 2008, 130(3): 031505 (8 pages)
Published Online: April 2, 2008
Article history
Received:
June 6, 2007
Revised:
July 3, 2007
Published:
April 2, 2008
Citation
Bobba, M. K., Gopalakrishnan, P., Periagaram, K., and Seitzman, J. M. (April 2, 2008). "Flame Structure and Stabilization Mechanisms in a Stagnation-Point Reverse-Flow Combustor." ASME. J. Eng. Gas Turbines Power. May 2008; 130(3): 031505. https://doi.org/10.1115/1.2836614
Download citation file:
Get Email Alerts
Image-based flashback detection in a hydrogen-fired gas turbine using a convolutional autoencoder
J. Eng. Gas Turbines Power
Fuel Thermal Management and Injector Part Design for LPBF Manufacturing
J. Eng. Gas Turbines Power
An investigation of a multi-injector, premix/micromix burner burning pure methane to pure hydrogen
J. Eng. Gas Turbines Power
Related Articles
Investigation of the Response of an Air Blast Atomizer Combustion Chamber Configuration on Forced Modulation of Air Feed at Realistic Operating Conditions
J. Eng. Gas Turbines Power (October,2003)
Orifice Diameter Effects on Diesel Fuel Jet Flame Structure
J. Eng. Gas Turbines Power (January,2005)
On the Adequacy of Chemiluminescence as a Measure for Heat Release in Turbulent Flames With Mixture Gradients
J. Eng. Gas Turbines Power (June,2010)
Flow Field and Combustion Characterization of Premixed Gas Turbine Flames by Planar Laser Techniques
J. Eng. Gas Turbines Power (March,2009)
Related Proceedings Papers
Related Chapters
The Identification of the Flame Combustion Stability by Combining Principal Component Analysis and BP Neural Network Techniques
International Conference on Mechanical Engineering and Technology (ICMET-London 2011)
Outlook
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Lay-Up and Start-Up Practices
Consensus on Operating Practices for Control of Water and Steam Chemistry in Combined Cycle and Cogeneration