The objective of this research is to identify optimal temperature sensor locations in a laminated die system for the purpose of predicting the temperature distribution throughout the die to control heating and cooling rates. Potential locations (referred to as target nodes) are grouped based on the similarity of their thermal response using both K-means and a proposed temperature ratio clustering method. A sensitivity analysis of the temperature distribution for these groups of target nodes identifies the sensor location for each cluster that exhibits the highest sensitivity to variable inputs. A comparison of sensor locations identified by each clustering method with the sensitivity analysis is presented and is used to evaluate the optimal sensor location in terms of consistency in generating these sensor locations, the degree of sensitivity, the mutual interaction through principal component analysis, limiting the number of sensors, and the accuracy in estimating the temperature distribution.
Skip Nav Destination
e-mail: jph@mecheng1.uwaterloo.ca
Article navigation
March 2012
Research Papers
Optimal Sensor Location in Laminated Die System
Jan P. Huissoon
Jan P. Huissoon
Department of Mechanical and Mechatronics Engineering,
e-mail: jph@mecheng1.uwaterloo.ca
University of Waterloo
, 200 University Avenue West, Waterloo, Ontario, Canada N2L 3G1
Search for other works by this author on:
Jan P. Huissoon
Department of Mechanical and Mechatronics Engineering,
University of Waterloo
, 200 University Avenue West, Waterloo, Ontario, Canada N2L 3G1e-mail: jph@mecheng1.uwaterloo.ca
J. Dyn. Sys., Meas., Control. Mar 2012, 134(2): 021013 (15 pages)
Published Online: January 12, 2012
Article history
Received:
February 25, 2010
Revised:
June 9, 2011
Published:
January 11, 2012
Online:
January 12, 2012
Citation
Seo, J., Khajepour, A., and Huissoon, J. P. (January 12, 2012). "Optimal Sensor Location in Laminated Die System." ASME. J. Dyn. Sys., Meas., Control. March 2012; 134(2): 021013. https://doi.org/10.1115/1.4005035
Download citation file:
Get Email Alerts
Cited By
Data-Driven Tracking Control of a Cushion Robot With Safe Autonomous Motion Considering Human-Machine Interaction Environment
J. Dyn. Sys., Meas., Control (July 2025)
Dynamic Obstacle Avoidance Strategy for High-Speed Vehicles Via Constrained Model Predictive Control and Improved Artificial Potential Field
J. Dyn. Sys., Meas., Control (July 2025)
An Adaptive Sliding-Mode Observer-Based Fuzzy PI Control Method for Temperature Control of Laser Soldering Process
J. Dyn. Sys., Meas., Control
Related Articles
On the Development of a Low Cost Pyrheliometer
J. Sol. Energy Eng (August,2011)
Experimental Investigation Into the Thermal Behavior of Copper-Alloyed Dies in Pressure Die Casting
J. Manuf. Sci. Eng (November,2006)
A Correlation Analysis of Cooling-Induced Temperature Changes
J. Manuf. Sci. Eng (February,2009)
Identification of Die Thermal Dynamics Using Neural Networks
J. Dyn. Sys., Meas., Control (November,2011)
Related Proceedings Papers
Related Chapters
Thermodynamic Performance
Closed-Cycle Gas Turbines: Operating Experience and Future Potential
Comparison of the Availability of Trip Systems for Reactors with Exothermal Reactions (PSAM-0361)
Proceedings of the Eighth International Conference on Probabilistic Safety Assessment & Management (PSAM)
Personnel and Requirements
Heat Exchanger Engineering Techniques